If there is a ground screw and it is not connected to the neutral with a strap or wire, follow the manufacturer's wiring diagram to make the proper ground-to-neutral connection. The wire makes an internal connection to the neutral. If there is a ground screw and it is connected to the neutral (center) terminal with a metal strap or small, white wire, leave the strap or wire in place. If there is no ground screw, no alteration is necessary. This is an internal neutral connection you will connect it to the neutral terminal along with the neutral cord wire just to keep it safely secured (it won't serve a purpose).
#Dryer plug installation pro#
The price of hiring an electrician will range from 40 to 100 per hour depending on the pro you choose. Each receptacle unit will cost between 3 and 50 depending on the type you need. The project typically ranges from 134 and 298. A new one can cost as little as 75 or as much as 485.
#Dryer plug installation install#
If there is a small white wire connected to the ground screw, remove it from the ground and fit it onto the neutral terminal on the block. The cost to install an electrical outlet averages 215. If there is a ground screw and it is connected to the neutral (center) terminal with a metal strap, remove the strap from the neutral terminal on the terminal block (you can remove the strap entirely or keep it attached under the ground screw). If there is no connecting strap or wire on the ground screw, the range is ready for the four-prong cord. If necessary, alter the ground-to-neutral connection as needed, depending on the type of cord you are installing: There may or may not be a ground screw near the terminal block-if present, this will be driven into the metal case of the appliance. There are three terminals in a line: the center terminal is neutral and usually has a white wire the left terminal is hot and may have a red or black wire the right terminal also is hot and may have a black or red wire. It should be several inches away from the wall.
Tightly secure the ends of the power cord and the strain relief with the screws, and then replace the terminal cover. Note the wiring configuration on the terminal block. Open the terminal block access cover and attach the ends of the power cord to the appropriate terminals. Alter the Ground Connection, If Necessary.Drill a hole using a 5/8 inch bit, the size recommended in 'Advanced Home Wiring' by Black and Decker, through the top sill in the attic above the dryer outlet and another above the breaker box. The Spruce Home Improvement Review Board Take the easiest route when installing a new circuit by running it up to the attic, over and down to the breaker service panel.
0 kommentar(er)
